Alaska Frontier Fabrication

Information

2020 American Turbine SD-203

ADVANTAGES TO USING AMERICAN TURBINE’S SUPER DUTY AXIAL FLOW JET

• For boats up to 5000 pounds all up weight. Maximum 330 horsepower.

• Engine and jet sit back as much as 8 inches farther back for more interior room.

• Bearing housing held on with six bolts instead of four to better support the rear of the engine.

• Completely sealed bearing housing water can’t come in around the driveshaft.

• A larger thrust bearing 35% more load capacity.

• Mechanical pump shaft seal never needs adjusting.

• Stronger 17-4ph stainless steel pump shaft.

• Solid stainless steel wear ring.

• Stainless steel 17-4ph impeller standard.

• Intake is stomp grate ready.

• 2.4 kw—3.1 kw impeller selection.

• Tandem lip seals on the bowl bearings, keeps grease in grit out.

• Axial flow design aids in passing sticks and stones.

• Nozzle inserts to fine tune your boat for optimum take-off, fuel economy and top speed.

• Standard with Split Duct Reverse (SDR).

• Very good reverse and low speed handling.

• Transom flange cast into suction housing, no need to make plates.

• Transom flange bolts to transom so the integrity of the transom is increased.

• Water off-takes are piped through the transom flange with a hose barb requiring less rigging time.

• Hand hole cover outside of transom for easier access.

• Will not over heat your engine at an idle.

• Operates well with excessive air ingestion.