Alaska Frontier Fabrication

Information

2020 American Turbine SD-312

ADVANTAGES TO USING AMERICAN TURBINE’S SUPER DUTY JET

• For boats up to 6500 pounds all up weight.

• Engine and jet sit back as much as 8 inches farther back for more interior room.

• Bearing housing held on with six bolts instead of four to better support the rear of the engine.

• Completely sealed bearing housing water can’t come in around the driveshaft.

• A larger thrust bearing 35% more load capacity.

• Mechanical pump shaft seal never needs adjusting.

• Stronger 17-PH stainless steel pump shaft.

• Tapered wear ring for infinite adjustment.

• Heat-treated aluminum impeller standard.

• Secondary wear ring on the rear of the impeller to prevent bowl cavitaiton.

• Jet will accept the 10” impeller.

• Tandem lip seals on the bowl bearings, keeps grease in grit out.

• Fifth generation bowl, better flow than any other mixed flow pump.

• Nozzle inserts to fine tune your boat for optimum take-off, fuel economy and top speed.

• Standard with Best nozzle, available HTR ll.

• Highest static reverse of any mixed flow pump.

• Transom flange cast into suction housing, no need to make plates.

• Transom flange bolts to transom so the integrity of the transom is increased.

• Water off-takes are piped through the transom flange with a hose barb requiring less rigging time.

• Hand hole cover outside of transom for easier access.

• Will not over heat your engine at an idle.